TM#1 has been moved from the south west silo to the south hot cell, move went well.

Electrical check on TM#1 with Ta#39 installed at the south hot cell. Target passed the electrical checks, see attached pdf for details.

TM#1 with Ta#39 has been moved from the south hot cell to the conditioning station move went well.

TM#1 with Ta#39 at the conditioning station, has failed its electrical test see attached pdf for details. Also while setting up for the electrical test one of the high powered flexible connectors popped out its crimp and another is working it out its crimp.

TM#1 with Ta#39 had the electrical check done on it again it passed, changes this time were the water lines were purged and it was under a better then roughing vacuum. See the attached pdf for details.

TM#1 with Ta#39 has not passed it electrical check again, while sitting at the conditioning station at air. The readings have not been consistant. See the current PDF for details.

TM#1 with Ta#39 electrical check at the target station see attached PDF (CHK 4).(April 9th 2013) PASSED

TM#1 with Ta#39 electrical check at the target station see attached PDF (CHK 5).(April 10th 2013) PASSED

TM#3 has been moved from the NE Silo to the south hot cell, move went well.

Electrical check was performed on TM#3 with no target nothing was wrong was found, but our megger does not go above 1000 volts so any problems above this value would not be seen, see attached pdf for details.

Also the 55 pin(top) double 9 pin (bottom) connector was tested as well. When it was meggered to 60kV common more then 50% of the lines failed, when those line were identified with a resistance package two were unable to be indentified. The wiring for this double 9 pin connector should be removed to prevent HV problems. New wiring is not physically possible to re-install in its place, see the PDF for the wiring details.

TM#3 with no target has been moved from the south hot cell to the conditioning station. Move went well. The fields around the module was 1.6mSv/hr.

TM#3 has been moved from the conditioning station to the south hot cell, move went well.

TM#3 with no target and no source tray has been moved from the south hot cell to the conditioning station.

TM#3 electrical check with no target and no source tray, see pdf.

TM#3 with no target or source trays has been moved from the conditioning station to the NE silo.

TM#3 with SiC#28 (RFQ Target) has been moved from the east target station to the south west silo.

TM#4 with SiC#28 has been moved from the south west silo to the south hot cell.

TM#4 with Ta#40 has been moved from the south hot cell to the conditioning station.

TM#4 with Ta #40 moved from the conditioning station to the east target station, move went well.

Results of the electrical check on  TM#4 with Ta#40, it passed. See attached PDF for results.

Spent target SiC#28 (RFQ Target) has been moved from the south hot to the storage vault. The target was placed in pail #105 in spot 2C of  the spent target vault. The target had a field of 24.8mSv/hr at about a meter upon removal from the south hot cell. See attached PDF for the status of the vault. It currently only has six free spots left.

The spent source tray for TM#3 has been removed from the south hot cell and well be placed in the the hot cell ante room. To sit till maintenance day to be moved over to the vault storage tunnels.