Results of electrical check on Ta#40 target on TM#4 post beam at the south hot cell

Electrical check on TM#4 with SiC#29 has been done. The reading of the magnet coil and 60kV common is low at 750 ohms, normally this infinite. Awaiting further instruction on if this is a pass or fail. See attached PDF for the rest of the details.

Electrical check of TM#4 with SiC#29 attached. Results are pretty much the same as yesterday for the coil to 60kV common, and anode to 60kV common. See attached pdf for details.

TM#1 with UCx#7 electrical check, numbers look good, see PDF for details.

TM#4 with SiC#29 post beam electrical check in the south hot cell see PDF for details.

Electrical check of TM#3 with no target was performed and it failed. There is a 135M Ohm short between the coils and a 165M Ohm short between the coil and 60kV common.  All other circuits passed they were infinite in value.

Electrical check was done on TM#3 yesterday and again the coil lines to the 60kV common and the coil line to each other failed, as in they had a resistance. Everything else passed as showing an infinite value, all meggering was done at 1000V unless noted other wise. See attached PDF for details.

The module was checked electrically this morning before the module move. See the attached PDF for details.

Electrical check of TM#3 in the conditioning station under vacuum see attached PDF for details.

Results of the various electrical checks done on TM#3 while at the hot cell since the 27th of September. View PDF for the details.

Travis Cave wrote:

Results of the various electrical checks done on TM#3 while at the hot cell since the 27th of September. View PDF for the details.

 There was also a leak check. There was some water remaining in the HS line but once removed the leak cart pumped down to 0.0 x 10-4 Torr and the leak tester was at the bottom limit. There was no response when sprayed with helium

TM#4 with SiC#29 electrical check post beam see pdf for details.

TM#3 with NiO#2 electrical check at conditioning station under vacuum, see pdf for details.

Electrical check done on TM#4 with no target, see PDF.

With the coil line removed an electrical check was done on TM#4 at the South Hot Cell see attached pdf.

Electrical check of TM#4 with Ta#41 post beam at the south hot cell. See PDF for details

Electrical check was done on TM#4 without a target and with the UC#8 target on see attached PDF for results.

TM#4 was checked electrically with and without target on it, see attached PDFs for details.

TM#4 with Ta#42 in the conditioning station under vacuum electrical check.

TM#3 electrical check at the south hot  cell with no target to give us a base line and show that things are ok with the module for the start of the running year.