Wednesday, February 05, 2025, 12:20

• Ed has the voltage already up to 1000 V. Starting further ramp up in 250 V increments.

Wednesday, February 05, 2025, 12:45

• Current was quite stable with basically no noise, and increasing with voltage until 57.5 kV, when the current spiked from 180 uA to a peak of 308 uA and the voltage dropped a little bit for a single data point. Kept it here for a few second and then dropped it back down a couple steps. Currently at 57 kV and the average current is about the same as before (181 uA), but the noise is significantly higher (+/- 10 uA).
• Been at 57 kV for about 5 minutes and no change in the noise. Will try continuing ramp.
• 57.25 kV: Current is ~193 uA with +/- 20 uA noise.
• Gonna go with 250 V step every 5 minutes from here on until 60 kV.

Wednesday, February 05, 2025, 13:17

• Seemed like it was having some trouble at 58 kV, and then at 58.25 kV it was fine for about a minute and just starting sparking constantly, and would not calm down after a minute. Some sparks caused a positive voltage swing up to 65 kV, and with currents as high as ~4000 uA.
• Ramped voltage down in steps back to 56.75 kV. It's still getting about 10-11 sparks per 5 minutes.
• Trying 56.5 kV. 8 sparks in 5 minutes, one positive.
• Trying 56.25 kV. 3 very small voltage drops in 5 minutes.
• Trying 56 kV. No voltage drops in 5 minutes. Current is on average ~204 uA, with +/- 20 uA of noise.

Wednesday, February 05, 2025, 15:02

• 1.5 hours at 56 kV. 2 small sparks over this time. Current was about 195 uA on average with about +/- 20 uA of noise. A spark will usually result in a change of the average current following the spark until the next.
• Ramping down voltage now. The amount of noise decreases quickly with voltage and is basically gone at 53 kV.
• Power supply off.
• Dumped data to https://isacwserv.triumf.ca/onlylocal/isacdata/ITE_HV_test_shutdown2025.txt

Conclusion: ITE seems good up to 56 kV.