TM#4 with Ta#46 has been moved to ITE from the conditioning station.

Dan and I connected TM4 in ITE. The turbo- pumps are started. Water supply to TM4 only at this stage. Everything is good so far.

The ITE is configured to take proton beam.

The ITE is configured to take proton beam.

During the weekend condition The TM4 spark at 30KV without vacuum response. It is confirmed the spark is from the top TM4 this morning.The flexible cables in a  black wire sleeve which is used for febiad X pin connection drooped too close to the TM4 surface plate, and caused the sparking. The problem is fixed by Anders and David. The cables is put back where it should stay.  After test, no sparking on the top.

Weekly update target hall schedule. See attachment 1,2.

TM4 has been connected in ITE. All turbo-pumps are started. Everything is good so far.

Dan and I transferred 4 shielding blocks from ITE to block storage area. The ITE pit is opened now.

TM4 has been disconnect in ITE(except  vacuum lines). The ITE vacuum system is still operating.

Dan and I finished TM4 and ITE annual leak check on primary and secondary vacuum vessel. We found one leak on a KF25  blank off which is located on the top of the service cap. It is a low E-7 atm.cc/sec range leak. But, it is very close to turbo-pumps so ITE IG1 and other gauges are not affected by it very much. It is an easy fix. TheKF -25 center ring on the blank off  will be replaced  after vent . It be will leak checked again at CS after replacement.  That is only leak we found on TM4 and ITE primary and secondary vessel air to vaccum leak check.

Dan and I also finished the helium pressure test on all TM4 using water circuits. 70 psi helium. base LR 0.0xE-9 atm.cc/sec. All of them are leak free. No any response has been found on leak detector during test.

TM#2 with SiC#32 has been moved from the west station to the south hot cell.

The ITE and TM4 have been vented with Argon . TM4 vacuum system is disconnected in ITE.

TM#4 with Ta#47 has been moved from the conditioning station to the east target station.

Tm4 has been connected in ITE. The ITE and TM4 is under roughing now. ITE

Turbo-pumps have been started. Everything is fine.

Dan and I disconnected TM4 in ITE. HS water lines has been purged.

Bill and Yasmine did the move. Everything is good.

TM#4 with UC#16 has been moved from the conditioning station to the east target station.

TM4 and ITE are under roughing now.

ITE is configured to take proton beam.

TM#4 with UC#16 has been moved from the east station to the south hot cell. The shield plug was also install remotely once it was hooked up due to alphas.