The containment box has been removed from TM2, the Enzel lens and steerers disconnected and optics tray removal has commenced.

 TM#2 has been moved from the conditioning station to the south hot cell.

Tm2 containment box has been re-installed onto TM2.

I have "slung" the TM4 optics tray in preparation for its removal.

 TM2 has been moved from the silo to the south hot cell.

On Thursday, June 29th the containment box of TM2 was removed and the optics tray re-installed and reconnected. The box was then re-installed.

Friday the window waterlines were leak checked, Nb target installed (with new fasteners, high current torqued to 130 in*lbs) target leak and electrical checked and containment box cover installed with new fasteners.

 The results of the various electrical checks performed on the TM#2 with and without the Nb#8 target attached.

 TM#2 with Nb#8 has been moved from the south hot cell to the west target station.

TM2 has been connected to ITW. All turbo pumps are started. See attachment for connection checklist.

Maico and Travis moved blocks from ITE to ITW yesterday

The 2A2M19 beam profile monitor did not work and was e-faulted. After initial troubleshooting 2 blocks were removed form ITW to inspect the entrance module where the beam monitor is installed. The cable was found not to be connected and was quickly fixed. Blocks reinstalled. The work was done by Maico, Travis and Anders

ITW Entrance Module was leak checked yesterday with the support of Vacuum Group (Dimo & Edi). The leak detector was connected to primary backing vacuum line. A leak response was found near the bellow for the beam profile monitor on top of the Entrance Module. It could be confirmed today by actuating the monitor, that the leak was indeed at that location. The plan is to move the TM and Entrance Module out for target exchange and repair, respectively. Drawings of the device available on ITA0200and ITA5128

 TM#2 with Nb#8 has been moved from ITW to the south hot cell.

 TM#2 with UC#23 has been moved from the south hot cell to the conditioning station.

The heat shield water lines were not purged ahead of target exchange in the hot cell. This resulted in water leaking onto the new target assembly (heat shield) when the cooling lines were opened at top and bottom (for connecting leak detector). Excess water was wiped up with paper towels.

 Both the West Entrance and TM#2 with UC#23 have been moved back into their places in the west target station. The Entrance module move wasn't completely smooth as it did suffer a little bumpiness when the shield plug part was installed, I was lifted back out again and no visible damage was observed on the delicate items.

 Electrical Checks of the last two targets Ta#56 and UC#23

 TM#2 with UC#23 has been moved from ITW to the south hot cell. The shield plug was also installed remotely as well.

 Results of the electrical check on TM#2 with no target after Chad cleaned out the bolt hole on the module where the target mounts.

 TM#2 with the nSiC#1 target had its check done on it at the south hot cell see attached for results.