CS roughing pump is started for TM4 and UCX 11 target.

TM#4 with UCx#11has been moved from the conditioning station to the east target station.

TM4 has been connected connect in ITE. Water is supplied to TM4 module only.

CS and TM4 was vented with Argon gas this morning before it was moved from CS to ITE.

5 Shielding blocks have been transferred from ITW to ITE. The ITE is configured to take proton beam.

4 shielding blocks have been moved out of  ITE to block storage area. Fiona did the survey and with me during the move.

TM4 waterlines have been disconnected and purged in ITE. The TM4 vacuum system is still in operation.

Gordon crane technicians continued their troubleshooting on this Tuesday. They found the crane up-limit protection switch which is installed on the same bracket with the the crane down view camera is broken. The spring inside the limit switch  which is used for pushing the action plunge out in the switch lost its function. This up limit switch is the last protection for the crane so it is set as when it is in action the crane main contact coil  which controls crane  power supply will be in open position. The broken switch is replaced by a new one( same type) on this Wednesday. The crane annual inspection has been  finished after the switch replacement. The crane works fine now.

Dan and I leak checked ITE primary and secondary vacuum vessels with TM4  in ITE. The leak detector was hooked to ITE TP2 BV2. Leak detector  base leak rate: 0.0xE-09 atm.cc/sec, base pressure: 0.0xE-4 torr. All secondary vacuum vessel seals has been checked(helium spray), and no leak has been found. On the ITE primary vacuum vessel, we  leak checked every thing except the TM4 service cap and water lines inside the TM4. NO leak has been found on ITE primary vessels. The primary vacuum seals on TM4 service cap and TM4 waterlines(helium pressure test) will be checked at CS later.

5 Shielding blocks have been moved to ITE for next week TM1 move and RPG Radon test.

5 shielding blocks have been transferred from ITE to ITW for next week TM4 move.

TM#4 with UC#11 moved from the east target station to the south hot cell.

TM#4 from south hot cell to the conditioning station no target is attached to the module.

TM#4  with no target has been moved from conditioning station to the south hot cell.

Ta#45 has been installed onto TM4 and is ready for leak and electrical check. High current fasteners torqued to 130 in.lbs.

TM#4 electrical checks with and without the target installed, installed target is Ta#45.

Chad and I leak checked TM4 HS water line with new Ta#45 target installed at SHC. Leak detector base leak rate 0.0Xe-9 atm.cc/sec, base pressure 0.0Xe-4 torr. Chad sprayed helium twice on each of HS 2 VCR joints.No leak has been found. The joints are leak tight. The helium pressure test  will be done at CS later.

I connected TM4 and CS vacuum system after TM4 move. CS roughing pump was started first this morning. Later, Anders, Bill and I started 3 turbo pumps on TM4 and CS. The pumping down is good so far. The CS vacuum system ion gauges are turned on also.

Electrical check of TM#4 with Ta#45 at the conditioning station, see attached pdf for details.

The helium pressure test on TM4 HS line at conditioning station is done. No leak. I also leak checked all vacuum seals on TM4 service cap. They are all good.