The HV cover is installed. The Faraday cage at B2 level is locked also.The TCS and TM2 are still pumping down. Everything is good so far.

I stopped TCS water pumps and vacuum pumps also.   TM2 and TCS will be vented tomorrow morning.

TM#2 with Ta#49 has been moved to the west target station from the conditioning station.

  ITW turbo pumps  have been started.

5shielding blocks have been transferred from ITE to ITE. ITW is configured to take proton beam.

TM#2 with Ta#49 has been moved from the west target station to the south hot cell.

TM2 was disconnected at ITW. 3 water circuits in ITW gave been looped to keep 75 GPM water flow to ITW. HS line was purged at HS. RPG got the water sample.

TM#2 has been moved from the south hot cell to the south west silo.

During target removal on Wednesday October 12th, the left target heater conductor bolt (ITD0058) could not be removed. The bolt was found to be stuck in the threads (keensert) of the TGHT conductor block (ITA0583). In the process of attempting to remove the bolt, the conductor insulator (ITD0054) cracked (ref assy ITD0052). To allow increased torque to be applied and support the conductor block, a clamping jig (ITD0612) was designed and fabricated. The jig was assembled and it's function tested on the ISAC Test Stand on Friday 14th. On Monday 17th the bolt could be removed using the clamping jig and a socket wrench with an extended handle.

The threads on the removed bolt was damaged. A new set of bolts were therefore prepared and a tap was run through the keensert to restore the threads. The threads in the conductor block was tested and found to be OK using a new bolt.

The spent target could now be removed. Unfortunately the right manipulator failed during installation of a new conductor insulator, which forced the repair of the insulator and installation of the new target (SiC#35) to be postponed until the manipulator can be repaired.

Photos are available on DocuShare

TM#2 has been moved from the south west silo to the south hot cell.

Sic#35 has been installed onto TM2. High current fasteners torqued to 130 in lbs.

Mating of the 9 pin connector was extremely problematic but in the end I was able to get it to mate properly. Noticed left (when facing module in hot cell) febiad coil left twisted a bit when torqued up.

Chad and I did the leak check on TM2 heat shield line. LD base leak rate:0.0xE-9atm.cc/sec. Base pressure:0.0X E-9 torr. The line is leak free.

Results of the electrical check of TM#2 with no target after the repair and with the SiC#35 mounted on the module.

All turbo pumps are started. Two gas valves for Febiad run are opened. Pumping down is good so far.

Update TH schedule after job delay on TM2 Febiad target. Everything should be back to schedule on last two targets. See attachments.

TM#2 with the old SiC #35 has been moved from ITW to the south hot cell.

Electrical check of TM#2 with the SiC#35  post beam run. See attached PDF for details.

TM#2 with UC#18 has been moved from the south hot cell to the conditioning station.

Results of TM#2 with UC#18 electrical at the south hot cell. See attached PDF for details.

Chad and I leak checked TM2 HS line with new UCx target installed. Helium spray  2 seconds on each joint and 10seconds flushing around target in SHC. LD base LR: 0.0XE-9atm.cc/sec, base pressure:0.0XE-4 torr. No response has been found on LD during check. The line is leak free.