TM#2 with UC#18 has been moved from the south hot cell to the conditioning station.

TCS will be vented tomorrow morning for TM2 moving.

Electrical check of TM#2 with the SiC#35  post beam run. See attached PDF for details.

TM#2 with the old SiC #35 has been moved from ITW to the south hot cell.

Update TH schedules . See attachments

All ITE and TM4  turbo pumps are started. The east station pumping down is good so far.

David Wang and I accessed the NHC today to check if the proposed duct routing (IRH1618) will interfere with servicing or replacement of the TCS turbo pump.  A piece of plywood was placed in the future position of the NHC/TCS partition wall (IRH1609), and a ducting elbow was placed at the approximate position of the nearest elbow to the turbo pump.

David concluded that the ducting in the proposed location will not have any significant effect on replacement of the turbo pump, and he does not expect replacement will be difficult to perform after installation of the wall and NHC ducting.  Standing at floor level towards the east side of the TCS space and reaching upwards seemed to be the best way to reach the turbo pump flange bolts.  It was also noted that there was sufficient room in the TCS space for two workers to be in the area.

TM#4 with Ta#50 has been moved to the east target station.

TCS is vented. TM4 is disconnected and TCS.

Spent SiC#34 was moved on the 3rd of November and  placed in the spent target vault. See attached pdf for details.

The system works fine. All water signals to TM4 at TCS are normal. HV cover is installed on to TM4 at TCS.

70 psi helium ,2minutes to  TM4 HS line. LD base leak rate 0.0xE-9 atm.cc/sec. No leak.

All turbo-pumps are started. The pumping down is good so far.

TM#4 with Ta#50 has been moved from the south hot cell to the conditioning station.

Chad and I did a leak check on TM4 HS line with new Ta target installed. Base leak rate 0.0xE-9 atm.cc/sec. base pressure 0.0XE-4.   splayed 2 helium to each VCR joints and did 10 seconds helium flush. No response on LD during the test. The HS line is leak free so far. It will be helium pressurized at TCS later.

TM4 was disconnected at ITE this morning. It was moved to SHC  after. No alpha alarm issue has been happened during and after move. The ventilation pumping down procedure on ITE was fulfilled during the move.

TM4 was disconnected at ITE this morning. It was moved to SHC  after. No alpha alarm issue has been happened during and after move. The ventilation pumping down procedure on ITE was fulfilled during the move.

Update TH schedule after job delay on TM2 Febiad target. Everything should be back to schedule on last two targets. See attachments.

All turbo pumps are started. Two gas valves for Febiad run are opened. Pumping down is good so far.

Results of the electrical check of TM#2 with no target after the repair and with the SiC#35 mounted on the module.