2A window has been removed from the vault and moved over the cyclotron vault tunnels.  Attached is the updated storage vault list.

Did the start of the running year electrical checks of both TM#2 and TM#4 with no target attached to either module. TM#2 was in the south hot cell and TM#4 is in the conditioning station under vacuum.

TM#4 has been moved from the conditioning station to the south hot cell.

Electrical check done on TM#4 with UC#19. See attached PDF for results.

TM#4 with UC#19 has been moved from the conditioning station to the east target station.

TM#1 has been moved from the North West silo to the conditioning station.

Results of an electrical check on TM#1 with no target attached to it.

 I use this e-log entry for TM1 notes as well  1. TM1 IG1 is a dual filament gauge . Its filament is very close to grid now. It shorted one time during the pumping down. It still works fine so far . But, we may need to change it if we use this module in TS again.

TCS 1G1 and 1G1S are pumped to 5Xe-6 torr. IG2 stayed at 2.5XE-5 torr. Since no target is installed on module , I capped top of HS water line. Maybe, the small o-ring seal in cap is too old, I found a big leak on this seal when i use LD check it. That is the reason IG2 stayed too high. Still, Leak check and helium presuure test are fulfilled on TM1. Leak detector BLR 5XE-7 atm.cc/sec, BP 0.0XE-4 torr9.  Back up pressure is 51 mtorr which is high because of leak on HS line cap seal so LD BLR is high. At this level, Ta+-, Tube +-, MSP,  EE are good.  Other air to vacuum seal are good as well at this leak rate.  I will check and change small o-ring seal in HS cap. The TM1 is functional basically.

 TM#1 has been moved from the conditioning station to the north west silo.  There was a slight delay in the move as the limits for the hoist drum got way out of whack and had to be adjusted.

Electrical check performed on TM#2 with Ta#51, see attached PDF.

TM#2 with Ta#51 has been moved from the south hot cell to the conditioning station.

 TM#3 is now in the south hot cell.

Electrical check of TM#3 with no target at the south hot cell

 TM#3 has been moved from the north east silo to the south hot cell.

Five spent targets have been moved from the target storage vault to the mini vault in preparation for Thursdays loading of the F-308s. See attached for the list of targets in the mini vault, and the new status of the storage vault.

 Mini Vault Door as some difficulty over coming a small hump on its track. To open the door one needs to give the door  a slight tug while it is opening to over come this hump.

TM#4 with UC#19 has been moved from ITE to the south hot cell.

TM#4 with UC#20 has had the electrical check done on it  at the south hot cell, see attached for details

TM#4 with UC#20 has been moved from the south hot cell to the conditioning station.

The spent UC#19 target has been moved from the south hot cell into the spent target storage. It was placed in pail #145 and put in tray one spot C. See attached PDF for all vault details.

Electrical check of TM#4 with UC#20 at the conditioning station under vacuum. See attached for details.