|
Logbooks
Lab Maintenance
Evaporator_1
Evaporator_2
Laser cutter
Target Production
Test-Stand
RH-ISAC
RH-Cyclotron
RH-Meson Hall
RH-Beamlines
RH-ARIEL
|
| Test-Stand |
Not logged in |
 |
|
|
 Friday, January 03, 2020, 11:56, Anders Mjos, , , , , , , Problems/Solutions, Upgrading BIAS Power Supply
|
 Friday, January 24, 2020, 16:01, Anders Mjos, , , , , , , Problems/Solutions, Upgrading BIAS Power Supply
|
|
|
Message ID: 780
Entry time: Friday, January 24, 2020, 16:01
In reply to: 776
|
| Author: |
Anders Mjos |
| Target/No.#: |
|
| Source: |
|
| Station: |
|
| Module: |
|
| Target Oven W.O#: |
|
| Heat Shield W.O#: |
|
| Status: |
Problems/Solutions |
| Subject: |
Upgrading BIAS Power Supply |
|
|
| Anders Mjos wrote: |
|
A new power supply was installed today by John Chow. Due to differences in pin configuration of the controls, a change to the cabling is required. Contacted controls (Julie) for support.
|
Ray from controls has updated EPICS and changed the cabling today. The power supply is operational.
NOTE: Current limit will need to be set in EPICS. Default value should be 0.1 mA for now. |