The installation of the module side water block jig has been successful.

 

During initial attempts yesterday afternoon, installation of the jig proved, as expected to be extremely difficult. This was primarily due a poorly position water block from a previous repair were the soldering jig had not been used to position the block; specifically coil 1. This is the same block that contributed with the difficulties in removing the old source tray.

 

I was able to utilize the water block polishing tools as handles to reposition this water block ( as well as another slightly difficult one) into its location in the water block jig.

 

Please be aware, as the jig was very difficult to install, it will be very difficult to remove later (as it was when removing the old source tray).

 

Chad